Brush Buster

Click here to view product label

• Controls brush and woody species around the home and garden
• Systemic postemergence herbicide for control of Poison oak, Poison ivy, Berryvines, etc.
• Prevents regrowth from tree stumps and shrubs
• Contains 32.15% active ingredient
• Available in 1 Pint size

Brush Buster is specifically designed to control woody plants in all residential areas. This product also controls many noxious perennial weeds on uncropped land.

The following is a partial list of the weeds controlled:

Alder, Ash, Aspen, Birch, Blackberry, Black cherry, Blackjack oak, Black locust, Box elder, Brambles, Buckbrush, Ceanothus, Chamise, Coffeeberry, Currant, Elderberry, Fir, Gooseberry, Greenbrier, Gum, Hemlock, Honeysuckle, Locust, Manzanita, Maple, Multifloral rose, Oaks, Osage orange, Palmetto, Pine, Poison ivy, Poison oak, Poplar, Red elder, Red elm, Salmonberry, Sand sagebrush, Serviceberry, Shinnery oak, Snowberry, Spruce, Sumac, Sycamore, Tulip poplar, Wild cherry, Wild grape, Wild rose, Winged elm, Yerba santa, and many other species.

To Prepare Spray

Add one-half the required amount of water to the spray tank, then add this product with agitation and finally the balance of the water with continued agitation. This material forms an emulsion in water, not a solution. This tends to separate on standing. Provide agitation to prevent such separation and ensure a uniform mixture.

For spot spraying with backpack sprayer, mix 2 cups (16 oz.) Brush Buster with 5 gallons of water. Wet brush stems and foliage thoroughly.

Drench the base of plants, then wet the lower 4/5 of remaining stems and leaves thoroughly to runoff. Apply treatment when brush is in full foliage. This method can be applied where susceptible species have been controlled by prior sprays and more resistant species, such as maple and oak remain. Soaking the base of the plant and wetting all stems to runoff is absolutely necessary for complete control.

For small (up to 3 inch diameter) stems, cut them as close to the ground as possible and apply undiluted Brush Buster directly from the can to the surface of the freshly cut stump.